MULTICAST OR UNICAST? Multicast can seem like a bandwidth-saving miracle. Please take time to consider the following information before enabling this feature. To update the address to another random value, click Generate Address. A suitable Multicast address is generated, but you can edit the result manually if you need to. In this context, please read the section entitled “Local-Link (Failsafe)” for additional information.Ĭlick Multicast (Figure 1-14) to transmit video using multicast, rather than the default unicast method. NOTE: Should Spark’s default IP Address setting (Dynamic) fail to provide a usable IP address within a minute or two – as when an active DHCP server is not found on the network – Spark will automatically switch to Manual mode and attempt to connect using a static IP address. To assign a static IP address to your Spark, change the IP Address setting to Manual. ![]() Your Spark’s IP Address resolution method is set to Dynamic by default, to take advantage of this scheme. Typically, your network will be configured to automatically supply IP addresses to devices you connect to it by means of a DHCP server. Too, the portion of the radio spectrum you are using may be serving numerous wireless networks in the same vicinity.Ī dedicated network helps minimize problems, as does careful channel selection – but a wired connection is always preferable in mission-critical settings. This problem worsens as more transmitters are added. The radio in a wifi router can only listen to one device at a time, forcing other devices to wait and retry repeatedly. Note: Wifi connections can produce very acceptable results, but performance issues may arise when many devices are connected. Prices subject to change without notice.Controls in the Network Settings section will be familiar to anyone who has connected a computer or mobile device to a network, and require little explanation. ![]() Please email or call first to check availability. There's simply no room left inside to fit a battery.Īlthough the Sparkbox overall dimensions and fit are the same as the EK, theĭesign requires a unique frame and covers, so original EK covers will not fit.Ĭanadian & Overseas orders- write for details. We offer the actuator (armature) clevis turned at 90 degrees to fit the Novoĭrive like original. We offer a lower mounting stud to fit the M bracket at additional cost. More details are in the owner's manual.Īs with the EK, the SPARKBOX is mounted using one bolt and a special stud. Type 3 Magneto Drive: Timing retard may also require a lighter drive spring for We offer a spring for the Type 2 at a small Type 2 Magneto Drive: Timing retard may not work unless a lighter drive spring ![]() Spark wire outlet: Plug wire exits the cover on the left hand side as shownĪnd is not reversible by the user as with the original EK.Ī right hand side version is available at additional charge Hardware of appropriate length (5/16-18 thread) to attach the Battery clips to attach the power cord to a battery. Longer wire at additional charge, see below. Though it can be replaced by the owner, we install the plug wire here during assembly as it is retained internally and more securely than the original EK.ġ2" standard length included. When ordering, specify the total length spark plug wire you need. We use an inexpensive dry-type lantern battery.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |